Most research peptides are supplied lyophilised — freeze-dried into a powder or "cake" at the bottom of the vial. Before the peptide can be measured out it has to be dissolved in a liquid, usually bacteriostatic water. This is called reconstitution. Done carefully it takes a couple of minutes; done roughly it can damage the peptide or contaminate the vial.
What you need
- The peptide vial
- Bacteriostatic water (3ml is standard for most vials)
- A reconstitution syringe — a larger syringe for drawing and transferring the water
- Alcohol swabs
- A clean, flat work surface
Every By & Large vial ships with a 3ml bacteriostatic water, a reconstitution syringe, insulin syringes and alcohol swabs, so you have everything in the box.
Step by step
- Let the vial reach room temperature. If it has been in the fridge, leave it out for 10–15 minutes. Cold vials are more prone to condensation and a sharp temperature change.
- Wash your hands and clear the work surface.
- Remove the plastic flip caps from both the peptide vial and the water vial, then wipe each rubber stopper with a fresh alcohol swab and let it air-dry.
- Draw the water. Pull the plunger back to the volume you want (for example 3ml), push the needle through the water vial's stopper, inject that air into the vial, then turn it upside down and draw the water out. Tap out any large bubbles.
- Add the water slowly, down the side of the vial. Insert the needle into the peptide vial at an angle so the tip rests against the glass, and press the plunger gently so the water runs down the wall. Don't spray it directly onto the powder.
- Swirl — don't shake. Gently roll the vial between your fingers or swirl it in small circles. Most peptides dissolve within a minute or two; some take longer. Vigorous shaking can create foam and may break down delicate peptides.
- Check the solution. It should be clear. If any powder remains, leave it to stand for a few minutes and swirl again.
- Label the vial with the date you reconstituted it and the volume of water you added.
Vacuum in the vial? Many vials are sealed under slight vacuum, so the water may be pulled in by itself. Keep a gentle hold on the plunger so it doesn't rush in and hit the powder.
Working out the concentration
Once dissolved, the concentration is simply the amount of peptide divided by the volume of water you added:
| Vial | Water added | Concentration |
|---|---|---|
| 10mg | 3ml | 3.33mg/ml |
| 10mg | 2ml | 5mg/ml |
| 30mg | 3ml | 10mg/ml |
| 50mg | 2ml | 25mg/ml |
More water gives a weaker solution, which makes small amounts easier to measure accurately; less water gives a stronger one. Whatever you choose, write it on the label — every later measurement depends on it. The reconstitution calculator does this maths for you and converts it into syringe units.
Common mistakes
- Squirting the water straight onto the powder
- Shaking the vial instead of swirling
- Re-using a needle between vials, or skipping the alcohol swab
- Forgetting to write down how much water was added
- Using plain sterile water when the vial will be accessed many times — see bacteriostatic vs sterile water
After reconstitution
A reconstituted vial should go into the fridge. See how to store peptides for temperatures and how long a vial keeps.
Research reference only — general laboratory handling information, not medical advice and not instructions for use in humans or animals. Updated 15 November 2026.